Posted by: Ashley Sebero December 24, 2010 06:26 am |
No, this is not the re-re-revival of my tesla coil project. No, this is not actually a project. Yesterday, I was bored, so I decided to design a vacuum tube tesla coil in EAGLE for use with my CX1140. I feel that I have come a long, long, LONG way from when I first started here in circuit design and analysis. Anyways, the design uses a couple of vacuum tubes to drive a flyback transformer, which produces 25kV. The 25kV is then rectified and fed into a thyratron based, adjustable frequency (depends on time constant of R4 and C3) relaxation oscillator, which outputs a sawtooth wave of 25kV p-p into the primary. I am not sure that the primary would like to be fed with a sawtooth, but I am sure you guys can enlighten me if there is a way to convert it to a sine wave. ----------------------- http://www.r4king.com/ps3-controller-charge-station.html http://www.r4king.com/3-in-1-wireless-remote-controller-keyboard-for-ps3.html http://www.r4king.com/5m-hdmi.html |